AMADOR COUNTY AIR POLLUTION CONTROL DISTRICT
RULE 427 - REGULATING CONSTRUCTION OR RECONSTRUCTION OF MAJOR SOURCES OF HAZARDOUS AIR POLLUTANTS
(Federal Clean Air Act Section 112 (g))
The purpose of this rule is to require the installation of best available control technology for toxics (T-BACT) at any constructed or reconstructed major source of hazardous air pollutants (HAPs). All T-BACT determinations shall ensure a level of control that the Air Pollution Control Officer (APCO) has determined to be, at a minimum, no less stringent than new source maximum achievable control technology (MACT) as required by the federal Clean Air Act (CAA), §112 (g)(2)(B) and implemented through 40 CFR, subpart B §§63.40-63.44.
The requirements of this rule shall apply to all owners or operators that construct or reconstruct a major source of HAPs, unless the major source is exempt pursuant to section (d).
Compliance with this rule does not relieve any owner or operator of a major source of HAPs from complying with all other District rules or regulations, any applicable State airborne toxic control measure (ATCM), or other applicable State and federal laws.
(c) EFFECTIVE DATE: This rule is effective on July 1, 1998.
(d) EXEMPTIONS: The provisions of this rule do not apply to:
Terms used in this rule that are not defined in this section have the meaning given to them in District Rule 102, Definitions.
Best Available Control Technology for Toxics (T-BACT)
T-BACT means the most effective emissions limitation or control technique which:
Construct a Major Source means the same as defined in 40 CFR §63.41 Definitions.
Hazardous Air Pollutants (HAPs) means any air pollutant listed in or pursuant to CAA, section 112 (b).
Major Source of HAPs means any stationary source or group of stationary sources located within a contiguous area and under common control that emits or has the potential to emit considering controls, in the aggregate, 10 tons per year or more of hazardous air pollutants or 25 tons per year or more of any combination of hazardous air pollutants.
Potential to Emit (PTE) means the maximum capacity of a stationary source to emit a pollutant under its physical and operational design. Any physical or operational limitation on the capacity of the stationary source to emit a pollutant, including air pollution control equipment and restrictions on hours of operation or on the type or amount of material combusted, stored, or processed, shall be treated as part of its design if the limitations or the effect it would have on emissions are incorporated into the applicable permit as enforceable permit conditions.
Reconstruct a Major Source means the same as defined in 40 CFR §63.41 Definitions.
No person shall construct a major source or reconstruct a major source of HAPs unless the APCO determines that the T-BACT requirements of this rule will be met.
(g) CALCULATION PROCEDURES
The potential to emit for a source of HAP emissions shall equal the sum of the potentials to emit of the constructed or reconstructed source of HAPs. All fugitive HAP emissions associated with the construction or reconstruction shall be included in the potential to emit determination.
(h) ADMINISTRATIVE PROCEDURES
An application for authority to construct a major source or reconstruct a major source of HAPs shall be subject to the administrative procedures contained in Regulation IV, Authority to Construct Regulations.