IMPERIAL COUNTY AIR POLLUTION CONTROL DISTRICT
RULE 1101 - NEW SOURCE PERFORMANCE STANDARDS (NSPS)
(Adopted 9/14/99)
A. Incorporation of Federal Standards
The provisions of Part 60, Chapter I, Title 40 of the Code of Federal Regulations (40 CFR Part 60), identified
in Section D. below, are incorporated herein and adopted by reference as part of the Rules and Regulations of the
Imperial County Air Pollution Control District. Applicable provisions of 40 CFR Part 60 include those incorporated
in the current bound CFR volume plus any provisions recently promulgated by U.S. EPA, as noticed in the Federal
Register, but not yet incorporated into the bound CFR. Where there are currently effective provisions which are
not yet included in the bound CFR volume, the Federal Register notice by which each provision was promulgated is
referenced at the affected subpart in Attachment I of this rule.
B. Applicability
All new stationary sources of air pollution, and all modified or reconstructed stationary sources of air pollution
shall comply with the standards, criteria, and requirements set forth herein. Whenever any source is subject to
more than one Rule, regulation, provision or requirement relating to the control of any air contaminant, the most
stringent provision shall apply.
C. "Administrator" means "APCO"
For the purpose of this Rule, the word "Administrator" as used in 40 CFR Part 60 shall mean the Air
Pollution Control Officer (APCO) of the District, except where the reference to "administrator" relates
to approval of alternate or equivalent test methods or alternative standards/work practices. U.S. EPA policy specifies
that the authority of the EPA Administrator for approval of these alternatives cannot be delegated to the APCO.
D. Attachment I, List of Incorporated CFR Provisions
The following table lists all 40 CFR Part 60 provisions which are incorporated in their entirety as part of
this Rule. Federal Register (FR) references are to currently effective provisions promulgated or revised by U.S.
EPA but not yet incorporated into the currently available CFR volume. Notations in this list indicate deviations
from the U.S. EPA-promulgated provision found in the CFR which have been adopted by the District Board for inclusion
in this Rule.
| CFR Subpart | Title |
| Subpart A | General Provisions |
| Subpart D | Standards of Performance for Fossil-Fuel-Fired Steam Generators for Which Construction is Commenced After August 17, 1971 |
| Subpart Da | Standards of Performance for Electric Utility Steam Generating Units for Which Construction is Commenced After
September 18, 1978 Note: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart Db | Standards of Performance for Industrial-Commercial-Institutional Steam Generating Units Note: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District |
| Subpart Dc | Standards of Performance for Small Industrial- Commercial-Institutional Steam Generating Units Note: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District |
| Subpart E | Standards of Performance for Incinerators |
| Subpart Ea | Standards of Performance for Municipal Waste Combustors for Which Construction is Commenced after December 20, 1989 and on or before September 20, 1994. |
| Subpart Eb | Standards of Performance for Municipal Waste Combustors for Which Construction is Commenced After September 20, 1994. |
| Subpart Ec | Standards for Performance for Hospital/Medical/Infectiou Waste Incinerators. |
| Subpart F | Standards of Performance for Portland Cement Plants |
| Subpart G | Standards of Performance for Nitric Acid Plants |
| Subpart H | Standards of Performance for Sulfuric Acid Plants |
| Subpart I | Standards of Performance for Hot Mix Asphalt Facilities |
| Subpart J | Standards of Performance for Petroleum Refineries |
| Subpart K | Standards of Performance for Storage Vessels for Petroleum Liquids for Which Construction, Reconstruction or Modification Commenced After June 11, 1973, and Prior to May 19, 1978 |
| Subpart Ka | Standards of Performance for Storage Vessels for Petroleum Liquids for Which Construction, Reconstruction, or Modification Commenced After May 18, 1978 and Prior to July 23, 1984 |
| Subpart Kb | Standards of Performance for Volatile Organic Liquid Storage Vessels (Including Petroleum Liquid Storage Vessels)
for Which Construction, Reconstruction, or Modification Commenced After July 23, 1984 Note: Any violation of provision 60.113.b., Testing Procedures, determined by Air Pollution Control personnel, shall constitute a violation of Subpart Kb |
| Subpart L | Standards of Performance for Secondary Lead Smelters |
| Subpart M | Standards of Performance for Secondary Brass and Bronze Production Plants |
| Subpart N | Standards of Performance for Primary Emissions from Basic Oxygen Process Furnaces for Which Construction is Commenced After June 11, 1973 |
| Subpart Na | Standards of Performance for Secondary Emissions from Basic Oxygen Process Steelmaking Facilities for Which Construction is Commenced After January 20, 1983 |
| Subpart O | Standards of Performance for Sewage Treatment Plants |
| Subpart P | Standards of Performance for Primary Copper Smelters |
| Subpart R | Standards of Performance for Primary Lead Smelters |
| Subpart S | Standards of Performance for Primary Aluminum Reduction Plants |
| Subpart T | Standards of Performance for Phosphate Fertilizer Industry: Wet-Process Phosphoric Acid Plants |
| Subpart U | Standards of Performance for Phosphate Fertilizer Industry: Superphosphoric Acid Plants |
| Subpart V | Standards of Performance for Phosphate Fertilizer Industry: Diammonium Phosphate Plants |
| Subpart W | Standards of Performance for Phosphate Fertilizer Industry: Triple Superphosphate Plants |
| Subpart X | Standards of Performance for Phosphate Fertilizer Industry: Granular Triple Superphosphate Storage Facilities |
| Subpart Y | Standards of Performance for Coal Preparation Plants |
| Subpart Z | Standards of Performance for Ferroalloy Production Facilities |
| Subpart AA | Standards of Performance for Steel Plants: Electric Arc Furnaces Constructed After October 21, 1974, and on or Before August 17, 1983 |
| Subpart AAA | Standards of Performance for Steel Plants: Electric Arc Furnaces and Argon-Oxygen Decarburization Vessels Constructed After August 7, 1983 |
| Subpart BB | Standards of Performance for Kraft Pulp Mills |
| Subpart CC | Standards of Performance for Glass Manufacturing Plants |
| Subpart DD | Standards of Performance for Grain Elevators |
| Subpart EE | Standards of Performance for Surface Coating of Metal Furniture NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart GG | Standards of Performance for Stationary Gas Turbines |
| Subpart HH | Standards of Performance for Lime Manufacturing Plants |
| Subpart KK | Standards of Performance for Lead-Acid Battery Manufacturing Plants |
| Subpart LL | Standards of Performance for Metallic Mineral Processing Plants |
| Subpart MM | Standards of Performance for Automobile and Light-Duty Truck Surface Coating Operations NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart NN | Standards of Performance for Phosphate Rock Plants |
| Subpart PP | Standards of Performance for Ammonium Sulfate Manufacture |
| Subpart QQ | Standards of Performance for Graphic Arts Industry: Publication Rotogravure Printing NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart RR | Standards of Performance for Pressure Sensitive Tape and Label Surface Coating Operations NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart SS | Standards of Performance for Industrial Surface Coating: Large Appliances NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart TT | Standards of Performance for Metal Coil Surface Coating NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart UU | Standards of Performance for Asphalt Processing and Asphalt Roofing Manufacture |
| Subpart VV | Standards of Performance for Equipment Leaks of VOC in the Synthetic Organic Chemicals Manufacturing Industry NOTE: The observation of a leak in excess of the requirements of the standard constitutes a violation of this Rule. This provision is added to Sections 60.482 through 60.484 and 60.482-7 through 60.482-8. |
| Subpart WW | Standards of Performance for the Beverage Can Surface Coating Industry NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. |
| Subpart AAA | Standards of Performance for New Residential Wood Heaters |
| Subpart BBB | Standards of Performance for the Rubber Tire Manufacturing Industry |
| Subpart DDD | Standards of Performance for Volatile Organic Compound (VOC) Emissions from the Polymer Manufacturing Industry |
| Subpart FFF | Standards of Performance for Flexible Vinyl and Urethane Coating and Printing NOTE: The 30-day emissions averaging periods specified in the federal standard are replaced with 24-hour emissions averaging periods for affected facilities in the District. The monthly basis used to calculate the VOC content from the source performance test in the federal standard is replaced with a 24-hour period to demonstrate compliance on a daily basis for affected facilities in the District. |
| Subpart GGG | Standards of Performance for Equipment Leaks of VOC in Petroleum Refineries NOTE: The observation of a leak in excess of the standard constitutes a violation of this Rule. This provision is added to Section 60.592.1. |
| Subpart HHH | Standards of Performance for Synthetic Fiber Production Facilities NOTE: The six-month rolling average basis specified in the federal standard is replaced with 24-hour emission averaging periods for affected facilities in the District. |
| Subpart III | Standards of Performance for Volatile Organic Compound (VOC) Emissions From the Synthetic Organic Chemical Manufacturing Industry (SOCMI) Air Oxidation Unit Processes |
| Subpart JJJ | Standards of Performance for Petroleum Dry Cleaners NOTE: The observation of a leak in excess of the requirements of the standard constitutes a violation of this Rule. |
| This provision is added to Section 60.622. | |
| Subpart KKK | Standards of Performance for Equipment Leaks of VOC from Onshore Natural Gas Processing Plants |
| Subpart LLL | Standards of Performance for Onshore Natural Gas Processing; SO2 Emissions |
| Subpart NNN | Standards of Performance for Volatile Organic Compound (VOC) Emissions from Synthetic Organic Chemical Manufacturing Industry (SOCMI) Distillation Operations |
| Subpart OOO | Standards of Performance for Non-metallic Mineral Processing Plants |
| Subpart PPP | Standards of Performance for Wool Fiberglass Insulation Manufacturing Plants |
| Subpart QQQ | Standards of Performance for VOC Emissions From Petroleum Refinery Wastewater Systems |
| Subpart RRR | Standards of Performance for Volatile Organic Compound Emissions from Synthetic Organic Chemical Manufacturing Industry (SOCMI) Reactor Processes |
| Subpart SSS | Standards of Performance for Magnetic Tape Coating Facilities |
| Subpart TTT | Standards of Performance for Industrial Surface Coating: Surface Coating of Plastic Parts for Business Machines |
| Subpart UUU | Standards of Performance for Calciners and Dryers in Mineral Industries |
| Subpart VVV | Standards of Performance for Polymeric Coating of Supporting Substrates Facilitie |
| Subpart WWW | Standards of Performance for Municipal Solid Waste Landfills (Promulgated 3/12/96, reference 61 FR 9905) |