SAN JOAQUIN VALLEY UNIFIED AIR POLLUTION CONTROL DISTRICT

RULE 2010 - PERMITS REQUIRED
(Adopted May 21, 1992, Amended December 17, 1992)

1.0 Purpose

The purpose of this rule is to require any person constructing, altering, replacing or operating any source operation which emits, may emit, or may reduce emissions to obtain an Authority to Construct or a Permit to Operate. This rule also explains the posting requirements for a Permit to Operate and the illegality of a person willfully altering, defacing, forging, counterfeiting or falsifying any Permit to Operate.

2.0 Applicability

The provisions of this rule shall apply to any person who plans to or does operate, construct, alter, or replace any source operation which may emit air contaminants or may reduce the emission of air contaminants.

3.0 Authority to Construct

Any person building, altering or replacing any operation, article, machine, equipment, or other contrivance, the use of which may cause the issuance of air contaminants or the use of which may eliminate or reduce or control the issuance of air contaminants, shall first obtain authorization for such construction from the APCO. An Authority to Construct shall remain in effect until the Permit to Operate the source operation for which the application was filed is granted or denied, or the application is canceled as described in Rule 2050 (Cancellation of Application).

4.0 Permit to Operate

Before any new or modified source operation described in Section 3.0, or any existing source operation so described may be operated, a written permit shall be obtained from the APCO. No Permit to Operate shall be granted either by the APCO or the Hearing Board for any source operation described in Section 3.0 constructed or installed without authorization as required by Section 3.0 until the information required is presented to the APCO and such source operation is altered, if necessary, and made to conform to the standards set forth in Rule 2070 (Standards for Granting Applications) and elsewhere in these rules and regulations.

5.0 Posting of a Permit to Operate

A person who has been granted a Permit to Operate any source operation described in Section 4.0 shall firmly affix such Permit to Operate, an approved facsimile, or other approved identification bearing the permit number upon the source operation, in such a manner as to be clearly visible and accessible. In the event that the source operation is so constructed or operated that the Permit to Operate cannot be so placed, the Permit to Operate shall be mounted so as to be clearly visible in an accessible place within 25 feet of the source operation or maintained readily available at all times on the operating premises.

6.0 Altering of Permit

A person shall not willfully deface, alter, forge, counterfeit, or falsify a Permit to Operate any source

This rule specifies emissions units which are not required to obtain an Authority to Construct or Permit to Operate. This rule also specifies the recordkeeping requirements to verify the exemption and outlines the compliance schedule for emissions units that lose the exemption after installation.