SAN DIEGO COUNTY AIR POLLUTION CONTROL DISTRICT
RULE 361.149 - STANDARD FOR WASTE DISPOSAL FOR ASBESTOS MILLS
Each owner or operator of any source covered under the provisions of Rule 361.142 shall:
(a) Deposit all asbestos-containing waste material at waste disposal sites operated in accordance with the provisions of Rule 361.154; and
(b) Discharge no visible emissions to the outside air from the transfer of control device asbestos waste to the tailings conveyor, or use the methods specified by Rule 361.152 to clean emissions containing particulate asbestos material before they escape to, or are vented to, the outside air. Dispose of the asbestos waste from control devices in accordance with Rule 361.150(a) or Section (c) of this rule; and
(c) Discharge no visible emissions to the outside air during the collection, processing, packaging, or onsite
transporting of any asbestos-containing waste material, or use one of the disposal methods specified in Subsections
(c)(1) or (2) of this section as follows:
(ii) Discharge no visible emissions to the outside air from the wetting operation or use the methods specified by Rule 361.152 to clean emissions containing particulate asbestos material before they escape to, or are vented to, the outside air.
(iii) Wetting may be suspended when the ambient temperature at the waste disposal site is less than -9.5¡C (15¡F), as determined by an appropriate measurement method with an accuracy of +1¡C (+2¡F). During periods when wetting operations are suspended, the temperature must be recorded at least at hourly intervals, and records must be retained for at least two years in a form suitable for inspection.
(ii) The suitability of the alternative method for the intended application.
(iii) The alternative method will not violate other regulations.
(iv) The alternative method will not result in increased water pollution, land pollution, or occupational hazards.
(d) When waste is transported by vehicle to a disposal site:
(ii) Conform to the requirements for 51 cm x 36 cm (20 in x 14 in) upright format signs specified in 29 CFR 1910.145(d)(4) and this paragraph ; and
(iii) Display the following legend in the lower panel with letter sizes and styles of a visibility at least
equal to those specified in this paragraph .
Legend 2.5 cm (1 inch) Sans Serif, Gothic or Block 2.5 cm (1 inch) Sans Serif, Gothic or Block 1.9 cm (3/4 inch) Sans Serif, Gothic or Block 14 Point Gothic |
(e) For all asbestos-containing waste material transported off the facility site:
(ii) The name and address of the local, State, or Environmental Protection Agency (EPA) Regional agency responsible for administering the asbestos NESHAPS program.
(iii) The quantity of the asbestos-containing waste material in cubic meters (cubic yards).
(iv) The name and telephone number of the disposal site operator.
(v) The name and physical site location of the disposal site.
(vi) The date transported.
(vii) The name, address, and telephone number of the transporter(s).
(viii) A certification that the contents of this consignment are fully and accurately described by proper shipping name and are classified, packed, marked, and labeled, and are in all respects in proper condition for transport by highway according to applicable international and government regulations.
(3) Report in writing to the local, State, or EPA Regional office responsible for administering the asbestos neshaps program for the waste generator if a copy of the waste shipment record, signed by the owner or operator of the designated waste disposal site, is not received by the waste generator within 45 days of the date the waste was accepted by the initial transporter. Include in the report the following information:
(ii) A cover letter signed by the waste generator explaining the efforts taken to locate the asbestos waste shipment and the results of those efforts.
(f) Furnish upon request, and make available for inspection by the Control Officer, all records required under this rule.
1. Work site name and mailing address: | Owner's Name | Owner's Phone # |
2. Operator's name and address | Operator's Phone # |
3. Waste disposal site (WDS) name, mailing address, and physical site location: | WDS Phone # |
4. Name and address of responsible agency: |
5. Description of materials: | 6. Containers # Type |
7. Total quantity m3 (yd3) |
8. Special handling instructions and additional information |
9. operator's certification: I hereby declare that the contents of this consignment are fully and accurately described above by proper shipping name and are classified, packed, marked, and labeled, and are in all respects in proper condition for transport by highway according to applic- able international and government regulations. |
Print/type name & title | Signature | Month Day Year |
TRANSPORTER
10. Transporter #1 (Acknowledgement of receipt of materials) |
Print/type name & title | Signature | Month Day Year |
Address City State Zip | Telephone # |
11. Transporter #2 (Acknowledgement of receipt of materials) |
Print/type name & title | Signature | Month Day Year |
Address City State Zip | Telephone # |
12. Discrepancy indication space | ||
13. Waste disposal site owner or operator: Certification of receipt of asbestos materials covered by this manifest except as noted in Item 12. |
Print/type name & title | Signature | Month Day Year |
INSTRUCTIONS WASTE GENERATOR SECTION (Items 1-9) 1. Enter the name of the facility at which asbestos waste is generated and the address where the facility is located. In the appropriate spaces, also enter the name of the owner of the facility and the owner's phone number. 2. If a demolition or renovation, enter the name and address of the company and authorized agent responsible for performing the asbestos removal. In the appropriate spaces, also enter the phone number of the operator. 3. Enter the name, address, and physical site location of the waste disposal site (WDS) that will be receiving the asbestos materials. In the appropriate spaces, also enter the phone number of the WDS. Enter "onsite" if the waste will be disposed of on the generator's property. 4. Provide the name and address of the local, State, or EPA Regional office responsible for administering the asbestos neshap program. 5. Indicate the types of asbestos waste materials generated. If from a demolition
or renovation, indicate the amount of asbestos that is:
- Nonfriable asbestos material 6. Enter the number of containers used to transport the asbestos materials listed
in Item 5. Also enter one of the following container codes used in transporting each type of asbestos material
(specify any other type of container used if not listed below):
DP - Plastic drums, barrels BA - 6 mil plastic bags or wrapping |
7. Enter the quantities of each type of asbestos material removed in units of cubic meters (cubic yards). 8. Use this space to indicate special transportation, treatment, storage or disposal or Bill of Lading information. If an alternate waste disposal site is designated, note it here. Emergency response telephone numbers or similar information may be included here. 9. The authorized agent of the waste generator must read and then sign and date this certification. The date is the date of receipt by transporter. NOTE: The waste generator must retain a copy of this form. TRANSPORTER SECTION (Items 10 & 11) 10. & 11. Enter name, address, and telephone number of each transporter used, if applicable. Print or type the full name and title of person accepting responsibility and acknowledging receipt of materials as listed on this waste shipment record for transport. Enter date of receipt and signature. NOTE: The transporter must retain a copy of this form. Disposal Site Section (Items 12 & 13) 12. The authorized representative of the WDS must note in this space any discrepancy between waste described on this manifest and waste actually received as well as any improperly enclosed or contained waste. Any rejected materials should be listed and destination of those materials provided. A site that converts asbestos-containing waste material to nonasbestos material is considered a WDS. 13. The signature (by hand) of the authorized WDS agent indicates acceptance and agreement with statements on this manifest except as noted in Item 12. The date is the date of signature and receipt of shipment. |