SAN DIEGO COUNTY AIR POLLUTION CONTROL DISTRICT

RULE 361.153 - REPORTING

(a) Any new source to which this subpart applies (with the exception of sources subject to Rules 361.143, 361.145, 361.146, and 361.148), which has an initial startup date preceding the effective date of this revision, shall provide the following information to the Control Officer postmarked or delivered within 90 days of the effective date. In the case of a new source that does not have an initial startup date preceding the effective date, the information shall be provided, postmarked or delivered, within 90 days of the initial startup date. Any owner or operator of an existing source shall provide the following information to the Control Officer within 90 days of the effective date of this subpart unless the owner or operator of the existing source has previously provided this information to the Control Officer. Any changes in the information provided by any existing source shall be provided to the Control Officer, postmarked or delivered, within 30 days after the change.
 

(1)     A description of the emission control equipment used for each process; and

(2)     If a fabric filter device is used to control emissions:
 

(i) The airflow permeability in m3/min/m2 (ft3/min/ft2) if the fabric filter device uses a woven fabric, and if the fabric is synthetic, whether the fill yarn is spun or not spun; and

(ii) If the fabric filter device uses a felted fabric, the density in g/m2 (oz/yd2), the minimum thickness in millimeters (inches), and the airflow permeability in m3/min/m2 (ft3/min/ft2).

(3)     If a HEPA filter is used to control emissions, the certified efficiency.

(4)     For sources subject to Rules 361.149 and 361.150:
 

(i) A brief description of each process that generates asbestos-containing waste material; and

(ii) The average volume of asbestos-containing waste material disposed of, measured in m3/day (yd3/day); and

(iii) The emission control methods used in all stages of waste disposal; and

(iv) The type of disposal site or incineration site used for ultimate disposal, the name of the site operator, and the name and location of the disposal site.

(5)     For sources subject to Rules 361.151 and 361.154:
 

(i) A brief description of the site; and

(ii) The method or methods used to comply with the standard, or alternative procedures to be used.

(b) The information required by Section (a) of this rule must accompany the information required by Rule 361.10. Active waste disposal sites subject to Rule 361.154 shall also comply with this provision. Roadways, demolition and renovation, spraying, and insulating materials are exempted from the requirements of Rule 361.10(a). The information described in this rule must be reported using the format of Appendix A of 40 CFR Part 61 as a guide.